C.R. Laurence Co., Inc.
Connecting the World to Everything Glass
 YOUR ACCOUNT               VIEW CART                SIGN INSIGN OFF

View Larger Image

Catalog Number: 33HPW
Finish: WHITE

  • Ready to Use for Wood and Metal Sash

  • Smooth Creamy Consistency

  • Must Be Painted

  • CRL DAP® '33'® Glazing Compound is smooth and flexible, and comes ready-to-use for face glazing wood and metal window frames. Its adhesion to both glass and sash is excellent, forming a dependable air and watertight seal that resists sagging, shrinking, chalking, and cracking.

    CRL White DAP® '33'® Glazing Compound - Half Pint


    Other Products/Finishes:

    33HPW CRL White DAP® '33'® Glazing Compound - Half Pint
    33PTW CRL White DAP® '33'® Glazing Compound - Pint
    33QTW CRL White DAP® '33'® Glazing Compound - Quart
    33GLW CRL White DAP® '33'® Glazing Compound - Gallon

    Catalog Number:33HPW
    Also Available in These Catalogs:
    CRL83R Door and Window Replacement, PAGE 873W
    CRL03 Sealants, Adhesives, and Fasteners, PAGE N181
    Size:Half Pint (237 ml)
    Ship Via:Can Ship UPS
    Shipping Weight:2 lb (907g)
    Case Qty:12
    Minimum Order:1 Each

    Separation occurs in glazing Putty; mix entire contents of container until completely uniformed before the application. If necessary, roll into coils to warm and soften.
  • *Surfaces should be clean, dry, and free of frost. When re-glazing, remove all old putty and bedding.
  • *Wood sash that is not primed or painted must be primed first with an oil-based primer and allowed to dry. When re-glazing, remove all old putty and bedding.
  • * Apply a thin layer of DAP® ‘33’® Glazing (about 1/8" thick) to backstop of sash to provide back-bedding where glass is to be set.
  • * For metal sash, use spacer shims at quarter points to maintain 1/8" minimum bedding thickness. There should be no metal or wood to glass contact.
  • *Smooth glazing to an angle that sheets water with a putty knife.
  • *Typical dry time before painting is one to two weeks, depending on temperature and humidity.
  • *Putty must be painted after it has skinned over and attained a firm set. Typical dry time before painting is one to two weeks, depending on temperature and humidity.
  • *For best results, use a high quality oil-based paint, or if using a latex paint, prime first with a high quality oil-based primer.

  • Important Note:
  • *Do not thin glazing compound.
  • *Do not apply when air or sash temperatures are below 40ºF (4ºC).
  • *Do not use on plastic window panes, insulating glass units with an organic seal, any window pane over 48" (1.22 m) in length, or metal sash with rabbets over 1-1/4" (32 mm) wide.
  • *Also not recommended for stained/leaded glass projects.
  • *Clean tools immediately after use with mineral spirits.

  • Most shipping weights are approximate and have not been verified. If the exact weight is needed in order to determine shipping costs, and shipping costs are required in order for you to complete your order, please request this prior to submitting your order by contacting CRL Customer Service. Product images shown are of the actual product or a close representation. ColorsColours can vary depending on your computer's video card and on how your monitor's colorcolour is adjusted.